Skip to main content

1.3

Minor Versionm

by Patrick Tessier

Introduction

By adding the TAP PAP CS to a dreamTAPTM, the prescriber can provide hybrid therapy for the patient. MAD + CPAP

  1. Use the 1.5 mm hex driver to remove the locking bolts. Don't drop the bolts.  They are very small and easily misplaced.
    • Use the 1.5 mm hex driver to remove the locking bolts.

    • Don't drop the bolts. They are very small and easily misplaced.

  2. Screw the connector rod on to the front of the mechanism. Use the same bolts you removed in step 1 Don't over tighten the bolts.  Snug, but don't strip the threads.
    • Screw the connector rod on to the front of the mechanism.

    • Use the same bolts you removed in step 1

    • Don't over tighten the bolts. Snug, but don't strip the threads.

  3. Use the bolt and nut to assemble the connector interface to the mask This can be adjusted to the patients needs:  Up, Down, Forward or Backward Finally, slide the interface on to the post.  This is a fairly tight fit.
    • Use the bolt and nut to assemble the connector interface to the mask

    • This can be adjusted to the patients needs: Up, Down, Forward or Backward

    • Finally, slide the interface on to the post. This is a fairly tight fit.

Finish Line

2 other people completed this guide.

Attached Documents

Patrick Tessier

Member since: 08/09/2017

56 Guides authored

Team

AMI Member of AMI

Community

11 Members

56 Guides authored

0 Comments

Add Comment