Skip to main content

1.2

Major VersionM

by Patrick Tessier

Tools

No tools specified.

  1. Heat the trays in a hot water bath (approx. 160 degrees F) until the ThermAcryl© turns clear. Do not leave the trays in the water bath too long. The trays will warp. Remove the ThermAcryl© with a spatula. Let trays cool. Place the ThermAcryl© beads in a hot water bath and heat until the beads coagulate and become clear. (You can buy the ThermAcryl© from your laboratory.)
    • Heat the trays in a hot water bath (approx. 160 degrees F) until the ThermAcryl© turns clear. Do not leave the trays in the water bath too long. The trays will warp.

    • Remove the ThermAcryl© with a spatula. Let trays cool.

    • Place the ThermAcryl© beads in a hot water bath and heat until the beads coagulate and become clear. (You can buy the ThermAcryl© from your laboratory.)

    • Coat the inner liner tray with a liquid monomer that will adhere the ThermAcryl© to the inner liner tray.

    • Fill the trays completely to the top with the heated ThermAcryl©.

    • Refit the trays to the patient (See Fitting the dreamTAP© ThermAcryl© Trays section).

Finish Line

One other person completed this guide.

Patrick Tessier

Member since: 08/09/2017

56 Guides authored

Team

AMI Member of AMI

Community

11 Members

56 Guides authored

0 Comments

Add Comment